Hydraulic Punch Tool
Hydraulic cylinder, puncher dies set 1/2"~4"Ø,
the max. size of circle hole:200Omm
- When the complete of electricity distributed tray, switch case, if want to change the
specification, it can be changed easily the size of dies and never destroy the surface after
punching.
- The size of dies can be ordered to make, quick delivery.
- Pump can match CTE-25AS, CP-700, CFP-800-1
- When order to make the rectangular and square type, it must measure the correct and
required sizes.
|
|
CC-104I |
CC-104II |
|
|
R-5(26mm)
1. Each size can be order to make.
2. Enclosed square angle of dies and axis |
RAM-A
THE SIZE FOR AXIS OF R-5
120mm Ø, 140mm Ø
150mm Ø, 180mm Ø |
|
Square and rectangular size
can be order to make. |
The Standards for hydraulic cylinder and hand pump
CFC-104III (CP-180+CC-104III )
CP-180 Hand pump
E.M.T Pipe for 19mm
25mm, 31mm, 39mm, 51mm
63mm, 75mm Conduit Steel Case.
Pump CP-180
CC-104III
The size equipment of then steel tube can see the figure. |
Our punching tools are classified to CC-104I (1/2"~2") Ø
CC-104II(2 1/2"~4") Ø
∗Note: Doesn't enclose the hydraulic cylinder when
ordering CC-104II.
- The max. thickness for punching iron-plate is up 3.2mm;
- The max. thickness for stainless steel plate is up 1.0mm.
- The max. punching capacity is up 16mm~200mm, but need
to match the bigger machine head. Output strength of CC-104A is 20 ton.
- Parts and razor dies are destroyed or lose, they can be order separately.
- Packing: PE box based on the combination of dies
|
|
.jpg)
